10mm 4x4 Residential
B10-MW-106
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
4x4 Residential (B10-MW-106)
Remove each set of foyer pieces (shown above)
from the sprue.
Glue together as shown above.
Glue this assembly to the back of a wall section,
aligning the lugs to the holes provided. Leave
these to dry.
Using the lugs on the roof piece, attach it to one wall
section. Add the corner bracers into position at each
end of the wall.
Work around the building attaching each wall
section in turn.
Finally glue the columns into position as shown.
