10mm 6x6 Residential
B10-MW-105
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
6x6 Residential (B10-MW-105)
Remove the four “L” shaped supports and four
outer walls from the sprue. Note that 2 outer
walls have 2 holes above the windows and 2
outer walls have 4 holes above the windows.
Glue the “L” shaped supports to the back of the two
outer walls which only have 2 holes above the
windows.
Attach one of the roof sections and the two outer
walls with 4 holes above the windows a shown
above.
Gently flex the open ends of the model and insert the
2
nd
roof piece and fourth outer wall. Leave to dry.
Glue one of the shop fronts into position.
Work around the inside, adding each shop front in
turn.
