Bloomfield Integrity 8746, Руководство пользователя

Страница: 4 / 12

9. After end of final cycle, turn tank heater
switch to ON position top portion of
switch rocker pressed in.
10. When tank water is up to proper temper-
ature, the green READY TO BREW light will
be lit.
NOTE: During the initial some
water will drip from spray disc.
This is normal.
11. Discard all water in reservoir and brew one (1)
additional cycle. CAUTION! Water dispensed from
spray disc will be HOT! Watch out for splashing.
If water level needs to be adjusted, see tea brewer
adjustments.
12. Discard water in six gallon dispenser, place
brew-through cover on dispenser then reposition
empty dispenser on brewer.
13. Place filter and tea in brew chamber. Slide brew
chamber into place on brewer.
14. Brewer is now ready for brewing tea.
BREWING
1. Place filter paper in brew chamber and add
5.
tea. Slide brew chamber into rails, pushing
it to full back stop location.
2. Check to see that reservoir with cover is pro-
perly located to accept dilute water spout
flow and brew chamber drain flow.
6.
3. Press brew switch to initiate brewing cycle.
4. Dilute water will begin to flow immediately 7.
into reservoir. Brewed tea will begin to flow
from brew chamber in about 20 to 30
seconds, and continue for approximately 10 to
12 minutes. Make sure drip-out is complete
before removing brew chamber.
If for any reason there is a need to stop the
brewing cycle before its completion, press the
“Brew Stop” switch. This stops water flow to the
brew chamber and the flow from dilute water
spout. The timing cycle is also cancelled and
timer resets to start.
Check level in reservoir - finished brew should
be approximately 1” from top edge.
Brewed tea is now ready for use. If a change in
strength is desired, add or reduce tea, to taste .
preference and continue for approximately 10 to 12
minutes. Make sure drip-out is complete before
removing brew chamber.
The brewer is factory adjusted to produce six (6)
gallons of tea in a 1-5
to dilute water ratio.
Should it become necessary to adjust for total
volume, follow these steps below.
3.
4.
TIMER ADJUSTMENT
(Total Volume Change)
1. Unplug unit.
5.
2. Remove four (4) screws (2 on each side of cover)
lift off cover to expose timer.
TEA BREWER ADJUSTMENTS
To brew more tea, turn knob slightly clockwise; to
brew less, turn slightly counterclockwise.
Plug unit in and cycle unit. Check for required
volume - repeat if needed, until desired volume
is attained. Replace cover on brewer.
Normal delivery should be six (6) gallons (766
ounces) of water.
Do not readjust setting of needle valve!
Page 4