Bloomfield Integrity 8746, Руководство пользователя

Страница: 3 / 12

INTRODUCTION TO THE UNITS
This manual covers the six (6) gallon tea brewer and the six (6) gallon tea dispenser.
1. The Model 8746 is the tea brewing section
only and does not have a storage dis-
pensing reservoir as part of the unit.
2. The Model 8806 is the six (6) gallon stainless
steel reservoir to hold the finish brew.
All brewers are shipped from the factory with:
1. A Stainless Steel Brew Funnel.
2. A Wire Grid to support the filter paper and
3. A 25 pack of Filter Papers, and
4. A Water Line Filter.
Electrical Requirements:
Plumbing Requirements:
Unit requires a power source capable of supplying:
115 Volt, AC., 60 Hertz, Single Phase, 15 Amp.
Service.
Unit must be installed on a water line with a flowing
pressure between 20 PSI and 90 PSI. If water
pressure does not fall into this range or varies
greatly a pressure regulator should be installed
The unit is shipped from the factory with a 3-wire,
polarized power cord and cap attached.
in the water supply line.
SET UP
1. Carefully remove brewer and tea reservoir
from cartons.
2. Set brewer in operating location and level,
using adjustable legs.
3. Connect water line to 1/4” flare fitting on
back of unit. Turn on water and check for
leaks.
4. Make sure tank heater switch on front panel
is in OFF position. portion of switch
rocker should be pressed in.
5. Plug unit into 110-120 Volt grounded outlet,
fused at 15 Amps.
6. Place reservoir under brewer.
7. Press momentary brew switch, to initiate
brewing cycle.
NOTE: Water will immediately begin to
flow from dilute water spout
CAUTION: During this initial fill cycle, check
level of water in reservoir. Before initiating
another brew cycle, the reservoir must be
emptied to prevent overfilling and flooding.
8. Repeat brewing cycles until water begins to
flow from spray disc.
Page 3