Blomberg TKF 1350, Руководство по эксплуатации, Страница: 14 / 20

14
• Press the “+”-button to adjust the time-
delay “1”, “2”, … until “19”, the “-“-button to
reset from “19” to “1”.
2. Press the button “Start/Pause/Cancel”,
the appropriate control indicator flashes,
the time-delay starts.
3. During the time-delay period more
laundry can be added. After adding, the
“Start/Pause/Cancel”-button must be
pressed again.
Aborting a time-delay
An active delay-time can be stopped at any
time:
1. Press the button “Start/Pause/Cancel”
for approximately 3-4 seconds – the preset
time-delay will be switched off. The control
indicator no longer flashes and the time
indicated on the display is annulled.
2. If you want to start the program immedi-
ately, simply press “Start”.
Changing time-delay
You can change the time-delay, if needed.
1. Press the “Start/Pause/Cancel”-Button.
The semicolon in the middle of the display
stops flashing.
2. Press the “+”-button to adjust the time
delay “1”, “2”, … until “19”, the “-“-button to
reset from “19” to “1”.
3. Press the button “Start/Pause/Cancel”,
the appropriate control indicator flashes,
the time delay starts.
Program progress indicator
During the program, a program progress
indicator will be on, indicating the current
program step.
“Drying”:
- is on during the entire heating time until
the drying level “Ironing dry” has been
reached.
“Ironing dry”:
- is on until the laundry has reached the
drying level “Linen cupboard dry”.
“Linen cupboard dry”:
- is on when the laundry has reached the
drying level “Linen cupboard dry”.
“Cool down”:
- during the ca. 4-minute long cooling-down
phase.
“End / Anti-crease”:
- during the anti-crease phase, until the
program has ended.
Important Advice
When several indicators are illuminated
simultaneously, there is a malfunction or
a problem. See chapter “Do it yourself,
when…”
Program Progress Indicators
Are illuminated during the following func-
tions and instructions:
• Time-delay when time-delay has been
adjusted (see “Time-delay).
• Child lock: if the child lock is active (see
also “child safety”).
• Clean fluff filter: at the end of a program
when the filter has to be cleaned. See also
Chapter Fluff filter.
• Empty the tank: at the end of the program
when the water tank has to be emptied or
when the drain hose is connected.
• Clean the condenser: in regular intervals,
after ca. 5 program cycles, when the filter
unit is to be cleaned and replaced. See
also Chapter Fluff filter/sponge filter unit.
After drying
The fluff filter
Fluff balls are rubbed off by wearing the
clothes– not by drying. When drying, these
fluff balls are trapped in the fluff filter.
Important Advice
The Fluff filter must be cleaned after every
drying operation!
Procedure:
1. Open the door.
2. Pull the fluff filter out of the door.
3. Carefully remove the fluff balls by hand