EN
11
12.
Reposition left hand side feet on the
opposite side.(10)
13.
Unscrew and remove the bottom
door hinge pin bushing/door stopper
using a cross-headed screwdriver.
(11)Unscrew and remove the upper
door middle hinge pin bushing/
door stopper using a cross-headed
screwdriver.
Important:
This part
cannot be used on the opposite
side; left hand side middle hinge pin
bushing/door stopper part is supplied
in the plastic bag.(11)
14.
Re-fit the upper hinge on the left hand
side using flat-headed screwdriver.
(12)
15.
Fit upper door left hand side middle
hinge pin bushing/door stopper
supplied in the plastic bag using
cross-headed screwdriver.(13)
16.
Reposition three small plastic plugs
on the left hand side, which are
covering middle hinge holes, on
the opposite side to cover holes left
empty.(14)
17.
Locate and re-fit upper door to upper
hinge and hold the door firmly.(15)
18.
Locate the middle hinge pin to
middle hinge pin bushing of upper
door on the left hand side and re-fit
the middle hinge.(16) First fit the left
screw when the door is closed and
then fit the right screw after opening
the door
for access.
19.
Reposition the screw fitted to lower
hinge hole on the left hand side at the
bottom of the cabinet on the opposite
side.(17)
20.
Locate and re-fit lower door to middle
hinge pin and then re-fit the lower
hinge on the left hand side.(18),(19)
21.
Carefully stand the appliance upright
and adjust the two front feet if
necessary.
22.
Check that doors open and close
easily, they are aligned correctly and
that there are no gaps allowing ir into
the cabinet. If there are gaps between
the door seal and the cabinet, adjust
the door seal by gently pulling away
from the door using fingers.
23.
Check that all the hinge screws are
tightened. Avoid over tightening the
screws.
24.
Put all items, fittings back in the
appliance.
25.
Fit upper door top trim and front top
panel plastic hinge covers. Upper
door top trim hinge covers are
supplied in the plastic bag.(20)
26.
Wait for at least 4 hours to allow the
system to settle before switching on.
27.
Once the correct storage
temperatures have been reached in
the appliance, put back all the food.
