1
Table of contents
Introduction
What should not be washed
in your dishwasher
Page
10
Loading the dishwasher
General .............................................................10
Lower basket .....................................................11
Cutlery basket ...................................................11
Upper basket.....................................................12
Page
10
5
6
Disposal
Page
3
Recycling.............................................................3
Disposal of your old machine..............................3
1
Safety Instructions
Page
3
Before installation................................................3
Before first use....................................................3
Childrens safety..................................................4
For daily operation ..............................................4
In the case of problems.......................................4
2
Get to know your machine
Page
5
View of the machine............................................5
Control panel.......................................................5
3
How to use your dishwasher
Page
6
Softening water ...................................................6
Filling the dishwasher salt...................................7
Filling the rinse aid dispenser .............................8
Filling the detergent dispenser............................8
4
22
Installing your dishwasher
Choose a suitable location for your dishwasher. Take
care to ensure that the machine is standing safely and
levelly.
Unevenness in the floor can be equalised by adjusting
the screw feet. When the machine is standing correctly,
the door can be closed without difficulties.
Water inlet and drainage hoses must be placed so
that they can move freely in order to avoid bending or
squeezing them.
The machine may not be hooked up in rooms with a
temperature below 0° Celsius.
Water connection
The dishwasher may be connected to cold and warm
water to a max. temperature of 60° Celsius.
The dishwasher may not be connected to open warm
water devices and flow-through water heaters.
Connect water inlet hose
Take care to ensure that the water inlet hose is not bent
or squeezed. Do not install a used hose set.
Use a screw-on hose connector to connect the water
inlet hose to a water tap with an external thread with a
measurement of 3/4 inches.
If required, use a filter inset to filter deposits from the
pipes.
Check that the connection does not leak.
Attention
For safety reasons, close the tap after every rinse
process.
Lowest permissible water
pressure:
0,3 bar = 3 N/cm² = 30 kPa
When the water pressure is
below 1 bar, please contact your
technician.
Permissible water pressure:
When the water pressure is above
10 bar, a pressure reduction valve
must be installed (available in trade
supply stores).
Highest permissible water
pressure:
10 bar = 100N/cm² = 1MPa
3/4
min 10
3/4
3/4 1/2
CH
DK
S
N
SF
