7
NOTICE: If this equipment is being installed at over 2,000 feet altitude and was
not so specified on order, contact service department. Failure to install with
proper orifice sizing may void the warranty.
CAUTION: The pipe thread compound used when installing pipes
must be a type that is resistant to the action of liquified petroleum or
propane gases.
ELECTRICAL CONNECTIONS
WARNING: Do not connect the appliance to the electrical supply
until after the gas connection has been made.
WARNING: ELECTRICAL GROUNDING INSTRUCTIONS
This appliance is equipped with a three-prong (grounding) plug for
your protection against shock hazard and should be plugged directly
into a properly grounded three-prong receptacle. Do not cut or
remove the grounding prong from this plug. (120V units only).
The wiring compartment is located behind the control panel. For units operated on
electrical supply other than 120 volts, remove the wiring compartment cover and make
electrical connections per the wiring diagram located inside the control housing cover
panel. The braising pan must be grounded in accordance with requirements of the
National Electrical Code or applicable local code.
Replace wiring compartment cover.
