Block PS-100+, Руководство пользователя

Страница: 23 / 26

23
Tone arm pad weight adjustment: first, install the counterweight of the tone arm by placing the
weight (with the scale facing forward) on the rear tube and turning it clockwise. Now the transport
lock of the tone arm can be removed. Move the tone arm to the turntable and adjust the arm for
beating by turning the counterweight. Now move the arm back to the tone arm support. Hold the
counterweight and turn only the scale so that the „0“ is at the top. For the pre-assembled sensing
system OM5E, set a value of 15 by turning the counterweight. This value corresponds to an aging
force of 1.5 g. For control please use a tone arm scale (not included).
To mount anti-skating weight: hang the loop of weight in the middle groove and guide the thread
through the eyelet of the guiding support. The value of the anti-skating setting depends on the se-
lected bearing force: 1 groove (from the front): 10 - 14 mN - 2 groove 15 - 19 mN - 3 groove 20 mN and
higher.
Connection to the amplifier: The NF connection box of the turntable is located at the rear right un-
derneath the device. Connect the supplied cable to the corresponding sockets. The ground cable is
attached to the middle screw.
Start-up: now you can put the felt mat on the turntable and remove the needle protector. After pla-
cing a plate and turning on the motor, the turntable is ready for operation.
We wish you a lot of fun with your new record player!