Blizzard Tournado WiMAX 7, Руководство пользователя

Страница: 7 / 24

Page 7
Tournado™ WiMAX 7 Manual Rev. A Copyright 2018 Blizzard Lighting, LLC
Before replacing a fuse, disconnect the power cord.
ALWAYS replace with the same type and rating of fuse.
3. SETUP
Fuse Replacement
CAUTION! The Tournado™ WiMAX 7 utilizes a high-output switch-mode power
supply with an internal fuse. Under normal operating conditions, the fuse should not
require replacement. Should your fixture require fuse replacement, please contact
Blizzard Lighting for instructions.
Data/DMX Cabling
For wired connections you’ll need to use data-grade DMX cables. Also, be sure to set
the fixture signal input in the menu to cable: SET > SIGN > CABL.
Fixtures on a serial data link must be daisy chained in one single line. Also,
connecting more than 32 fixtures on one serial data link without the use of a DMX
optically-isolated splitter may result in deterioration of the digital DMX signal. The
maximum recommended cable-run distance is 500 meters (1640 ft). The maximum
recommended number of fixtures on a serial data link is 32 fixtures.
Using The Built-in W-DMX™
In addition to the unbridled thrill you already received the first time you turned it
on, you’ll be delighted to know that this unit is designed to work seamlessly with any
W-DMX™ product. W-DMX™ is a two-time award winning wireless DMX technology,
created and owned by Wireless Solution Sweden AB.
To use the built-in W-DMX™ receiver, you will first need a W-DMX™ transmitter
or transceiver to broadcast the signal, such as our own LightCaster™ W-DMX™
transceiver unit. Paired up with a LightCaster™ W-DMX™ transceiver, you can
expect an outstanding wireless range of up to 500 meters (line-of-sight), and leave
any worries behind concerning loss of signal due to its built-in FHSS technology
(Frequency Hopping Spread Spectrum).
FHSS are frequency hopping techniques, in which the
transmitter jumps from one sub-channel to another
at a very rapid pace. This technique was first used by
the U.S. military precisely because they are difficult
to disrupt, and unless you knew the frequency
hopping sequence, practically impossible to intercept.
Make sure to read the instruction manual of your
LightCaster™ W-DMX™, or other W-DMX™ transmission device for other product
specific setup information.