TO ENSURE OPTIMAL PERFORMANCE FROM YOUR ICEMAKER, THE
FOLLOWING IS RECOMMENDED –
•
Ensure that the minimum water temperature is not lower than
+5°C
or higher than
+40°C
•
Minimum water pressure is not below 0.1MPa and maximum does
not exceed 0.5MPa
•
The electrical supply available corresponds to the voltage and
ampacity of the machine specifications as indicated on the rating
plate
•
The electrical cut off switch with fuse protection must be a 2 pole
type with minimum clearance of 3mm between open contacts
•
The minimum ambient temperature should not be lower than
+10°C
or the maximum higher than
+40°C
•
Ensure there is a minimum space around the cabinet vents of
150mm to allow air circulation.
•
Ensure there are no heat sources (kitchen stoves, cookers, radiators
etc) near the machine and the environment isn’t too humid.
INSTALLATION
•
Check the machine is level, and connect the plug to the electrical
cord in compliance with local regulations
•
Replace any old/used water hoses with new ones and connect to the
water supply
•
Ensure the drain is connected and set up properly using a spiralled
hose. It should have a minimum fall of 3cm per metre
•
Open water shut off valve
•
Insert plug into mains socket and set the main switch to the ON
position.
