Blizzard Lighting KRYO.MIX CMY, Руководство пользователя

Страница: 17 / 24

Page 17
Kryo.Mix™ CMY User Manual - Rev. B (c) 2017 Blizzard Lighting, LLC
Gobo Replacement
1) Disconnect the fixture from power and allow to cool.
2) Position the head and apply the tilt lock.
3) Remove the rear head cover located on the same side as the pan lock
4) Remove the slot-n-lock gobo from the gobo wheel by lifting up slightly and sliding it out.
5) Using a small tool, pry the tension ring from the gobo holder.
6) Remove the old gobo, insert the new gobo, and replace in the reverse steps of removal.
ATTENTION:
- The original gobos supplied in this fixture use a special coating, specifically designed to
resist the high internal temperature.
- Custom gobos will similarly need to use an approved gobo type. Blizzard has tested
“Type 3” and “KO/G05/P05/DY” type gobos available from gobosource.com with excellent
results.
- Any fixture damage caused by using an unapproved gobo type/supplier will not be cov -
ered under warranty!
Troubleshooting
Symptom Solution
Fixture Auto-Shut Off Check the fan in the fixture. If it is stopped or moving slower than normal, the
unit may have shut itself off due to high heat. This is to protect the fixture from
overheating. Clear the fan of obstructions, or return the unit for service.
Beam is Dim Check optical system and clean excess dust/grime. Also ensure that the
220V/110V switch is in the correct position, if applicable.
No Light Output Check to ensure fixture is operating under correct mode, IE sound active/auto/
DMX/Etc., if applicable.
No Power Check fuse, AC cord and circuit for malfunction.
Blown Fuse Check AC cord and circuit for damage, verify that moving parts are not restricted
and that unit’s ventilation is not obstructed
Slow Movement Check that speed channels are set appropriately.
No Response to Audio Verify that the fixture is in “Sound Active” mode.
Adjust Audio Sensitivity, If Applicable.
Fixture Not Respond-
ing / Responding
Erratically
Make sure all connectors are seated properly and securely.
Use Only DMX Cables.
Install a Terminator.
Check all cables for defects.
Reset fixture(s).
Fixture Moving On
Its Own
Verify proper mode of operation. Is the fixture in “Auto” mode?
If your problem isn’t listed, or if problems persist,
please open a support ticket at www.blizzardlighting.com/support.