BlitzRCWorks EFLY-6CIII, Руководство по эксплуатации

Страница: 16 / 18

16 www.blitzrcworks.com
ADJUSTMENTS
CHARGING THE TRANSMITTER
Procedure:
1. Correctly and safely power off by pulling throttle stick and throttle trim all lowered first and then turn off
aircraft and transmitter last. Transmitter must be turned off in order to charge. The transmitter cannot
charge if it is still on.
ADJUSTING CHANNEL VALUES
1. Enter into the Chv menu.
2. Press the left or right button to check whether the channels are in the right positions. Your settings for
channels 1, 2, and 4 should be set to 0%. The minimum value of channel 3 should be -100% and the maximum
should be 100%. If the curve setting value has changed, it should be set to the set value. If the values are
different, please adjust the channels and its mid points. This is strongly recommended for using this
transmitter for the first time.
SERVO REVERSING
Check every servo's movement to make sure every movement of the control arms and servo arms are correct.
If not, please enter into the Rev menu to reverse that servo's setting.
ADJUSTING POSITIONS OF AILERON, ELEVATOR, AND RUDDER
1. Check the centering position of the aileron, elevator and rudder.
2. Turn on the transmitter first and then lower the throttle stick and throttle trim tab all the way down. Turn on
the aircraft last.
3. Try moving each servo individually with your transmitter to make sure that each are moving properly.
Make sure every servo control arm is set at a 90º angle with the servo. Adjust the length of the control linkage
rod and that the control arms are in a neutral position.
ADJUSTING THE MOVEMENT RANGE OF SERVOS
Check for how much each servo can move and that it is centered. If you aren't able to move the servo much
and seem to be restricted, you can adjust the position on of the clevis on the servo control arm.
ADJUSTING THROTTLE CONROL
Check if the throttle is operating correctly in accordance to the controls on the transmitter. If your throttle is
going full when the stick is all the way down and that it is powering down when you push the throttle stick up,
you can adjust it by reversing the throttle in channel 3.
LEFT RIGHT
N/DOWN
SUB
2. Connect the wall adapter to the transmitter's charging port.
3. Check if the input voltage rating is the same as the charger
and then plug it into the wall outlet.
4. Charging time should be no more than 5 hours. If you have
not used or operated the transmitter in a while, it is best to
recharge it before using again.
Note:
1. Only the 9.6V Ni-HM rechargeable battery can be charged.
The dry cell should not be charged
2. To prolong the battery life, make sure not to overcharge at
more than 5 hours.