BlitzRCWorks EFLY-6CIII, Руководство по эксплуатации

Страница: 11 / 18

11
C
A
B
D
www.blitzrcworks.com
Mode 1 and Mode 2 settings:
1. Press the sub button to enter into the Mode 1 and Mode 2 settings menu.
2. Before setting the mode, make sure the plane is turned off (battery is
unplugged).
3.
Adjust the joysticks.
The screws shown in the figure A and B help to suppress the springs.
Screws C and D adjusts the resistance of the sticks.
For Mode 1, loosen screws A and C but tighten screws B and D/
For Mode 2, loosen the screws for B and D but tighten A and C.
4.
Press the left or right button to select a mode.
Press Y/UP button to confirm.
“left” stands for Mode 2 and “right” stands for Mode 1.
You can now finish the channel calibration.
LOW VOLTAGE WARNING
OTHER FUNCTIONS OF THE TRANSMITTER
When the voltage of the transmitter battery is low, the red LED will flash.
When this light flashes, it is best to bring your aircraft back down and to
stop flying until you have charged the battery. Ignoring this warning can
cause crashes and damages to your aircraft along with possible injuries.
USING THE CHARGING PORT
The charging port is located on the side of the transmitter and is specifically designed for charging the
transmitter battery with the battery still in the transmitter. Please make sure the batteries are installed
correctly and to not overcharge the battery.
ADJUSTING THE JOYSTICK'S LENGTH
1.Turn the head of the joystick counterclockwise to extend the length
and clockwise to shorten. Please do not extend it too much as it can fall
off or break.
2.Tighten the lower part of the joystick by turning it counterclockwise.
Counterclockwise to extend
Clockwise to shorten
ADJUSTING THE JOYSTICK SPRING
The joystick spring can be adjusted and it is possible to adjust the
aileron, elevator, or rudder.
1. Turn the screw on the transmitter back counterclockwise to
remove the back covering.
2. Turn the screw of the channel to adjust the spring.
Turn it clockwise for more resistance and
counterclockwise to make it loose.
3. Put the back of the transmitter back into place
and tighten the screws to close.
screw adjustment
screw adjustment
screw adjustment