Blitz Junior Jack 0, Инструкция по эксплуатации и список запасных частей

Страница: 17 / 22

Instruction Manual for Mobile Jacks
17
 After the fluid change, bleed the lift. (

6.8)
6.7 Replacing the hydraulic hoses
E

Retract the piston rod [1] completely.
 Disconnect the lift from the mains.
 Remove the bleed screw and install the cover D. (

3.1)
 Place the lift horizontally.
In case of inground carriages, remove the lift cylinder first. (

3.2)

Disconnect the hydraulic hoses and attach new ones.
 Position the lift vertically.
In the case of inground carriages, reset the lifting cylinder into the carriage.
 Remove the cover D and check the load lifting hydraulic fluid level. (

6.4)

Reinstall the bleed screw and bleed the lift. (

6.8)
6.8 Bleed the lift
 Operate the manual pump [4] approximately 5 to 10 times, and at the same time actuate the
drain valve [3].
 Extend and retract the piston rod [1] completely.

Repeat as needed.
6.9 Clean or Replace the Pneumatic Control Valve
F E G H
A
C
B

Disconnect the lift from the compressed air
supply.
 Remove the snap ring A, pull out axle B, and
remove pedals C.

Remove bolt E and remove the cover F and the
control valve G to the front.

Replace the O-ring H, attach a new control
valve, and fasten again with the bolt E.
 Attach the pedals C and the axle B and secure
with the snap ring A.