Features & Controls
Features & Controls
1.REMOTE CONTROL INPUT ( Pig-1 )
2.BASS BOOST SWITCH - ON and OFF
3.VARIABLE LOW-PASS FILTER(40Hz ~ 350Hz)
When Crossover Mode Selector is in Low Pass Mode, this control limits
the frequencies which will be distributed to the speakers to those below
the value to which this is set within the range 40~350Hz.
4.MODE CONTROL
Adjust the crossover for your chosen installation method.
-LPF : Low pass filter- only bass tones go to speakers. Use with woofer or
sub-woofer.
-HPF : High pass filter - blocks very low tones from the speakers.
-FULL : No filter - all tones go to speakers. Use with full-range speakers,
or with external crossovers.
5.VARIABLE HIGH-PASS FILTER(40Hz ~ 3kHz)
When Crossover Mode Selector is in High Pass Mode, this control limits
the frequencies which will be distributed to the speakers to those above
the value to this is set within the range 40Hz~3kHz.
6.INPUT LEVEL(INPUT SENSITIVITY ADJUSTMENT)
This control adjust the amplifier's input sensitivity. Input sensitivity is
variable from 100Millivolts to 4 volts. Clockwise increases sensitivity.
Counterclockwise decreases sensitivity.
This knob is not a volume control signal levels. A lower signal level will
require increased sensitivity for full power. A higher signal level will
require decreased sensitivity.
7.LINE INPUT RCA JACKS
These inputs are for signal cables from the source. Always use high
quality shielded RCA cables.
8.LINE OUT RCA JACKS
The LINE OUT allows you to build multiple amplifier systems without
having to use splitter cords to distribute the signal. Now it is simple
a matter of bringing one set of RCAs into the first amplifier, then
using the line out RCA jacks as the feed to the next amplifier.
5
