Blitz BP 65-215, Руководство по эксплуатации

Страница: 4 / 10

5
110425 03/13
Operating Instructions
King pin press
Technical data
Press capacity t 65
Stroke mm 120
Nominal pressure bar 420
Air supply max. bar 13
Weight kg approx. 130
Oil fill volume l approx. 35
Loudness level db(A) > 60
High-speed pneumatic lift and return
Operation and use
• Only use the king pin press on a solid,
level surface.
• Before starting the press, always check
the oil level (approximate fill volume 3.5 l
HLP22).
• Position the press as close as possible to
the vehicle axle and use the shortest pos-
sible stroke for the hydraulic work.
• The spindles in the press frame must
always be securely tightened with the atta-
ched nuts.
• When adjusting the press to the vehicle,
always make sure that the crosspiece and
press frame are parallel.
• The press frame can also be detached
from the trolley and used for appropriate,
suitable jobs (NB: be careful not to bend
the air and hydraulic hose or damage it in
any way).
• After using the king pin press, lower the
piston fully to prevent possible damage
and to avoid unnecessary loading on the
return spring.
• Pull out the side lever rod before moving
the trolley.
• The attached rapid lifting valve can be
used to extend and retract the piston
quickly (without load); UP = extend and
DOWN = retract the piston.
Venting the press cylinder
• The press cylinder can easily be vented if
required: Partially extend the piston rod;
using a size 4 hexagon socket, slightly
loosen the headless screw in the centre
of the location hole on the piston rod and
then tighten it again once the air has been
released.
Maintenance and repairs
• Maintenance and repair work on the press
may only be carried out by trained person-
nel. Always make sure the press is depres-
surised before starting work.
• The pump body and spindles must be kept
clean at all times.
• Do not allow the press to be damaged by
foreign bodies.
• Make sure that the pressure hose is in
good condition and that the connections
are clean.
• Drain off condensation water in the sight
glass on the service unit if necessary.
• Change the oil once a year.
110425 03/13