BLiNQ Networks Inc.
X-1200 System Installation Guide
Release 1.0
Confidential - Restricted Use and Duplication
Page
18
Issue 01 D1
Figure 7 Attaching Assemble Pole/Wall Mount Bracket to Pole with Straps
6.3.4
Mounting onto a Wall
The pole/wall mounting bracket has four wall-mounting holes that you use to mount the HM or RBM
directly onto a wall.
Required parts and tools:
Pole/wall mount bracket with attached pole clamps; see Section 6.3.1, “Attaching Pole Clamps to
Mounting Bracket”
Four customer-provided 5/16-in. or M8 wall mounting bolts or equivalent
If the wall material requires it, customer-provided bolt reinforcement hardware (for example,
four wall shoe anchor bolts)
Socket wrench with 3/8 in. driver head, with long and short ½ in. and 7/16 in. sockets
Torque wrench, 3/8 in. head with range for 4-60Nm or 3-45lbf-ft
Black marker
To install the pole/wall mount bracket onto a wall, refer to Figure 8, “Attaching Assembled Pole/Wall
Mount Bracket to Wall” and follow these steps:
1.
Identify an area on the wall that meets the safety, space, and environmental requirements for the
HM or RBM.
2.
Place the pole/wall mounting bracket onto the location on the wall. Mark the locations of the four
wall-mounting holes using a black marker.
3.
If required, install the bolt reinforcement hardware onto the wall at the four mounting hole
locations.
Note:
The installer should mount the bolt reinforcement hardware to the wall with the correct
distance apart so that when the bolts are installed through the mounting bracket wall mount holes
they align with the holes in the wall.
4.
Install and hand-tighten the four mounting bolts through the pole/wall mounting bracket and into
the wall. Ensure the orientation cut-out is pointing up (see Figure 4, “Pole/Wall Mount Bracket”).
5.
Use the socket wrench to evenly tighten all four bolts of the pole/wall mount bracket to the wall.
Top View
