Grain Mill
© Blichmann Engineering, LLC 2020
For replacement parts, visit: blichmannengineering.com/genuine-replacement-parts
3
Stand Assembly:
The Mill has an optional stand available in two different sizes. Each are assembled in the same order. Only
tighten fasteners finger tight until the entire assembly is put together. Adjust the straightness of the stand
and then tighten each fastener no more than 1/8 turn past tight.
Tools Required:
10mm Combination Wrench
17mm wrench (Casters)
9/16” wrench (Feet)
Insert and press fit the 8 long the carriage bolts into outside holes of the top
board and lay the board down with the screw threads facing up.
(Figure 1)
Install the four leg mount angles with the large washers and nuts.
(Figure 2)
Install the legs and attach the 3 leg braces. The front of the board is the edge
closest to the hole. Don’t install a leg brace on the front of the stand, see
diagram for designation. If using the feet attach the feet to the legs now.
(Figure 3)(Figure 4)
If you are using a caster kit, attach the large board to the stand using the
casters and hardware. Lock the caster to keep the stud from spinning during
installation.
(Figure 5)
Do not install chute until the mill is installed
Install the canvas grain chute as shown. Note that one edge is longer than
the other.
(Figure 6)
1.
2.
3.
4.
5.
Figure 1
SMALLER SIDE
IS THE FR
ONT
LONG BOLTS
Figure 2
Figure 3
Figure 4
Legs go on the outside
Figure 5
Figure 6
Long
Short
