Blaupunkt MPS 1402C MB, Инструкции по эксплуатации и монтажу

Страница: 3 / 8

INTRODUCTION
Proper system planning is vital in order to
maximize the device’s performance and road
safety. Plan your installation carefully to avoid
compromising performance reliability of the
system. Consult an authorized Blaupunkt dealer
for installation or preparation. Read the manual
carefully before operating the device for the
first time.
Safety notes
Ensure to follow below safety notes during
installation and wiring connection: -
•
•
•
•
•
•
•
•
•
Voltage Supply
•
•
•
•
Integrated Fuse
The integrated fuse in the device protects the
output voltage and the entire electrical system
in case of malfunction. Do not replace damaged
fuse with higher current.
Switching On/Off
This device will automatically turn on if a music
signal is detected. The device will also automati-
cally turn off if no music signal is received.
Recycling and Disposal
Please dispose responsibly.
Subject to change.
Disconnect the negative terminal of the
battery. Refer to the safety notes of vehicle
manufacturer.
Ensure positions of the holes are nowhere
near the vehicle component to avoid any
damage during drilling.
Ensure cross section of the cable is no less
than 2.5mm2 if the positive and negative
cables are too long.
Incorrect installation may result in malfunc-
tion of the device or the car sound system.
Installation and Connection Instructions
Select a dry and well-ventilated location to
install the device.
The device must not be installed in overly
exposed location such on the rear shelf, rear
seat etc.
The installation location must be suitable for
screw holes and have stable ground support.
Disclaimer
In no event shall Blaupunkt be liable for any
direct, indirect, punitive, incidental, special
consequential damages, to property or life,
improper storage, whatsoever arising out of
or connected with the use or misuse of our
products.
USA & CANADA : Products not intended
for sale in the United States and Canada. If
purchased in the U.S. or Canada, this product
is purchased as-is. No warranty, express or
implied is provided in the U.S. and Canada.
Use the supplied power extension cable to
connect to the positive battery terminal.
Firmly and carefully connect the ground lead
to a bare metal point on the vehicle chassis.
The control of the device should be a
two-channel control, either via the preampli-
fier output of the car sound system.
A control solely via the right or left channel is
also possible since the low-frequency portion
of the music is generally identical on both
channels.