3
Away Arm
1. Enter a Control Panel User PIN
Code +
Arm
Key.
2. Press
Arm
Key + put Tag on
Keypad.
Home Arm
1. Enter a Control Panel User PIN
Code +
Home
Key.
2. Press
Home
Key + put Tag on
Keypad.
Disarm
1. Enter a Control Panel User PIN
Code +
Disarm
Key.
2. Press
Disarm
Key + put Tag on
Keypad.
If Remote Keypad is set to
Arm without Use PIN code
(
*
+
8
under Test Mode)
Away Arm
Press
Arm
Key
Home Arm
Press
Home
Key
Disarm
Enter a Control Panel User PIN Code
+
Disarm
Key
If Remote Keypad is set to
Arm with Keypad PIN code
(
*
+
0
under Test Mode)
Away Arm
Enter Keypad PIN Code +
Arm
Key
Home Arm
Enter Keypad PIN Code +
Home
Key
Disarm
Enter Keypad PIN Code +
Disarm
Key
Checking Control Panel Status
Press the Status key to inquire Control Panel status, the Status LED will light up
according to Control Panel mode.
Red LED On
Away Arm mode
Red LED Flash
Home Arm mode
Blue LED on
Disarm mode
Dual Key Alarm Function
Dual Key Alarm function will activate alarm when both keys are pressed at the
same time. To use the functions, please enable them under Test Mode. (Default
are disabled)
1
+
3
Panic Alarm
4
+
6
Fire Alarm
7
+
9
Emergency Alarm
LEDs
Active LED
The Active LED light up whenever any key is pressed.
Status LED
The Status LED light up during operation or when the
Status
key is pressed to
inquire Control Panel status
Red LED On
Away Arm mode
Red LED Flash
Home Arm mode
Blue LED On
Disarm mode
Blue LED Flash
• No reply from Control Panel
• Incorrect PIN code
• Request for Home arm when under
Away arm mode
• Request for Force Arm
Fault LED
The Fault LED light up whenever faults are detected in the alarm system.
Orange LED On
Alarm in memory
Orange LED Off
Fault exists in system
Battery
The Remote Keypad uses one 3V lithium battery as its power source. It also
features low battery detection function to notify the Control Panel when battery
voltage is low.
When the Remote Keypad is on low battery, follow the procedure below to
change the batteries.
1. Open the back cover
2. Remove the old batteries
3. Press any key several times to fully discharge.
4. Insert the new batteries observing correct polarity.
5. Replace the back cover.
Factory Reset
If you forget your Keypad PIN code, or the Remote Keypad has any problem,
you can reset the Remote Keypad to factory default.
1. Open the back cover and remove the battery
2. Press and hold
3
key and insert battery
3. The Remote Keypad will sound 3 short beeps
4. Release
3
key, the reset process is now complete
4. Specification
Environmental Condition
-10°C to 40°C, relative humidity 85% non-condensing.
Radio
868 MHz
Arm/Home/Disarm
If Remote Keypad is set to
Arm with Use PIN code
(
*
+
9
under Test Mode)
Off
Keypad in Standby Mode
Blue LED On
Keypad in Normal Operation
Blue LED Flash
Keypad in Normal Operation and
under Low Battery
Orange LED On
Keypad in Test Mode
Orange LED Flash
Keypad in Test Mode and under Low
Battery
English
