CS3010 4010
TREE FELLING
Before you start felling the tree, you should have a closer look at it. Considering the slope of the tree,
the direction of the wind, the location of heavier branches, the slope of the terrain determine the
direction of the tree fall. Secure the area and make sure whether the falling tree will not cause any
damage to the property nearby. Check the escape route for any obstructions.
Small trees with a diameter of less than 15 cm can be cut with a single cut. If the trunk is thicker make
the felling cut.
Make a cut to 1/3 of the depth of the tree on the side on which the tree is to fall. Make a felling cut
slightly above the opposite side of the cut.
CLEANING AND MAINTENANCE
NOTE! Make sure that the device is switched off and disconnected from the power source
before starting cleaning or maintenance.
After finishing work, the device should be cleaned of debris and dust.
Clean the housing of dust using a delicate brush, paint brush or cloth.
Cleaning with a damp cloth is allowed, but only if the device is dried immediately. Protect metal parts
with oil.
Clean the ventilation slots regularly. Use compressed air or a vacuum cleaner.
After every 5 hours of operation, check the condition of the guide bar and chain. Remove sawdust from
the guide bar groove and the oil hole. Lubricate the chain guide sprocket through the guide
lubrication hole (6).
Take care that the chain is always sharp. If a blunt chain is used, the guide and other structural
components of the device will wear more quickly. In the extreme situation, the chain may break. It is
recommended to have the chain sharpened by trained professionals.
In case of prolonged storage keep the device in a well-ventilated room, free of moisture and protected
from dust. Make sure to put the guard on the cutting unit and keep the device out of the reach of
children.
TROUBLESHOOTING
Malfunction
Saw does not start
The chain saw is not working
evenly, with breaks
The chain is dry
Possible cause
No power
Malfunctioning on/off switch
Empty chain lubrication oil reservoir
Damaged power cord
Damaged fuse
Safety brake activated
Damaged power cord
Solution
Check the plug, cord and power source
Have it repaired for service
Top up the oil in the reservoir
Have it repaired for service
Have it repaired for service
Release the safety brake
Have it repaired for service
10
Содержание CS3010
