4
Before Installing the
Equipment
Transport Locking Screws
The mechanism in the CD changer is
“locked” by the transport screws during
shipping. Make
certain to remove these screws before
installing the changer.
Note:
After removing the transport locking
screws, place the enclosed seals over
the screw holes. These seals prevent
dust from entering the device, which
could lead to malfunctions.
Precautions for Installation and
Wiring
1. Do not install the equipment in the
following locations:
- Locations that are exposed to di-
rect sunlight.
- Locations at which warm air exits
the car heating system.
- Locations in which proper instal-
lation is impossible and locations
in which many vibrations are pro-
duced.
2. - Make certain to use the brackets
and screws supplied.
- When installing the equipment, do
not use any screws that are part
of the braking or steering systems.
3. The device may only be installed in
the approved manner (on one of its
sides, on one of its ends, at an angle
of 45
°
, or suspended. If it is installed
upside-down or with the front facing
down, malfunctions may occur.
BEFORE INSTALLING THE EQUIPMENT
