17
Boston RCC 45
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Recall: Press FM
T
as many times until
the display shows “T”. Then briefly
press one of the preset buttons 1, 2, 3,
4, 5, or 6.
>
M•L
To select the MW or LW waveband.
Press button as many times until the
desired band is adjusted.
?
Code LED
May flash for additional theft protection
when the car radio is switched off (see
DSC CODE-LED).
Important notes
Precautions
Before starting to use your new car radio,
please read the information on “Traffic safe-
ty” and “Anti-theft coding” carefully.
Traffic safety
As the driver of a motor vehicle, it is your
responsibility to pay attention to the traffic
situation at all times. Never use your car radio
in a way that could distract you.
Please keep in mind that you travel a di-
stance of 14 m per second at a speed of only
50 km/h.
Should the traffic situation become particu-
larly demanding, we advise you not to use the
radio.
Always make sure that you are still able to
hear any warning signals coming from outsi-
de of the vehicle, such as police or fire engine
sirens, so that you can react accordingly.
Always select a moderate volume for playing
your car radio while you are driving.
QuickOut
This car radio is optionally available with or
without the QuickOut release bracket.
With the QuickOut handle you can easily pull
the unit out of the installation compartment in
order to take your Blaupunkt with you when
you leave your car. The preset stations will
remain stored even for a longer period of
time.
To remove the set,
•
press knob (“a”) and pull the radio out
with handle (“b”).
To re-install the unit,
•
insert the radio until it stops and move
the handle back to the front panel.
If the security coding system is switched off,
the set will be ready for use immediately.
If the security coding system is active, pro-
ceed as described under „Re-start following
an interruption of the power supply“ each
time the set is re-inserted.
Installation/Connection
Your new car radio is equipped with security
coding. To switch the anti-theft protection on
or off it is necessary that the set is connected
to permanent 12 V supply.
If you would like to install this equipment
yourself or add any new components, please
read the enclosed installation and connec-
tion instructions carefully.
Do not connect the loudspeaker outputs to
ground!
Use only the accessory and replacement
parts approved by Blaupunkt.