Blaupunkt BDR-500, Руководство пользователя, Страница: 7 / 90

User manual BDR-500 / BDR-501
7
Connecting power
Connect an AC adapter (not supplied) to the DC IN 6V jack of the unit and to the mains socket.
Caution!
• Check that the voltage marked on the adapter rating plate matches your local supply.
• Never use an AC adaptor that is damaged, route power lead in a safe manner and make sure it is not subjected to
trapping or pinching. If the power lead is damaged refer to a qualified service agent.
•The AC adaptor is used as the disconnect device and it shall remain readily operable. To be completely disconnected the
power input, the AC adaptor shall be disconnected from the mains completely. The AC adaptor should not be obstructed
or should be easily accessed during intended use.
Battery operation
1. Remove the lid of the battery compartment by sliding it outward in the direction of the arrow.
2. Insert 4 R6/UM3/AA batteries into the compartment. Make sure to match their polarities (+/-) to the markings inside the
compartment.
3. Replace the lid.
Notes on batteries (not supplied)
·Do not mix different types of batteries or old batteries with new ones.
·Never recharge the batteries, apply heat to them or take them apart.
·Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
·Do not throw the batteries in fire!
·Attention should be drawn to the environmental aspects of battery disposal.
·The batteries need to be replaced when: The volume decreases, or sound is distorted during operation.
·The appearance of battery icon “
” on display indicates that the batteries are low. Replace them with new batteries.
·In order to avoid leakage, remove the batteries when unit will not be used for a long period of time.
·Please respect the environment. Before throwing any batteries away, consult your distributor who may be able to take
them back for specific recycling.
Caution!
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
SETTING TIME
After the batteries are installed, the display will show “0:00”.
1. Press
MEMO once to enter time setting mode. The display will show flashing “24 HOUR”. Then press tuning / to
select 24H or 12H time format.
2. Press
MEMO again to confirm and the hour digits flash.
3. Press tuning / to set the hour value. Press MEMO to confirm and minute digits flash.
4. Press tuning / to set the minute value and press MEMO again to confirm.
SETTING THE ALARM
Set alarm time
2. In Standby mode, long press ALARM button until “ALARM” indicator display and hour digits flash on display.
2. Press tuning / to adjust hour value. Then press ALARM to confirm and minute digits flash.
3. Press tuning / to adjust minute value and press ALARM to confirm.
Set wake up source
Press ALARM repeatedly to select the wake up source among “ ” and “ ”.
• WAKE UP TO THE BUZZER SOUND
displays and buzzer sound will come out when the alarm time is reached.
• WAKE UP TO THE RADIO
3. Follow procedures in “Listen to the radio” to select your desired radio station and adjust the alarm sound level.
4. displays and radio sound will come out when the alarm time is reached.
Checking Wake Time
Long press ALARM until you see a flashing wake time.
Silence the alarm momentarily
Press SNOOZE to turn the alarm off temporarily. The alarm will sound again when the snooze period is over.
BLAUPUKT
TECH
SA