8
General
We provide a manufacturer's warranty for our products
purchased within the European Union. You can view the
guarantee conditions at www.blaupunkt.de or ask for
them directly at:
Blaupunkt GmbH
Hotline CM/PSS 6
Robert Bosch Str. 200
D-31139 Hildesheim
Installation and safety notes
Please read the following information carefully before
plugging in your signal controller.
The negative terminal on the battery must be discon-
nected while the device is being installed and con-
nected.
Observe the safety notes from the vehicle manufacturer
(airbag, alarm systems, on-board computers, immobilis-
ers).
Before drilling holes, ensure that no routed cables or
vehicle components are damaged!
When installing the device, choose a place where the
signal controller can be securely screwed in so that it does
not hinder the driver or endanger the vehicle occupants
should the vehicle come to an abrupt stop, e.g. in the case
of emergency braking.
The IR remote control may not be installed in the deploy-
ment area of air bags (driver side, passenger side, side
impact air bags) or in the head or knee impact area!
The customer should check and ensure all aspects of the
holding force of the adhesive pad on the mounting surface
at the installation point.
Accessories
We recommend using only accessories approved by
Blaupunkt.
Scope of delivery
The scope of delivery of this signal controller includes all
the parts listed below. Check whether the scope of delivery
of your device is complete. Please contact your dealer im-
mediately if one of the listed parts is missing.
●
Signal controller 7 607 003 551
●
Connecting cable
●
Screws
●
IR remote control
●
IR receiver
●
Operating and installation instructions
Switching on/off
Switching on the signal controller
The signal controller is switched on via the "+12V Ignition"
switching cable from the connected control device.
GENERAL NOTES
02_IVSC 5502_gb.indd 8
02_IVSC 5502_gb.indd 8
30.01.2007 10:31:29 Uhr
30.01.2007 10:31:29 Uhr
