38
Installing the appliance
1. Remove the pan supports, the burner lid and
flame spreader and carefully turn the
appliance upside down and place it on a
cushioned mat.
Take care that the Ignition devices and flame
supervision devices are not damaged in this
operation.
2. Apply the sponge provided around the edge
of the appliance.
3. Do not leave a gap in the sealing agent or
overlap the thickness.
Sponge
The thickness of the sponge is 3 mm.
The width of the sponge is 10 mm.
Bottom view
Do not use a silicon sealant to seal the
appliance against the aperture.
This will make it difficult to remove the
appliance from the aperture in future,
particularly if it needs to be serviced.
1. Place the bracket (B) over the holes that match the
size of the screws. There are one set of screw
holes in each corner of the hob (H).
Slightly tighten a screw (C) through the bracket (B)
so that the bracket is attached to the hob, but so
that you can still adjust the position.
2. Carefully turn the hob back over and then gently
lower it into the aperture hole that you have cut out.
3. On the underneath of the hob, adjust the brackets
into a position that is suitable for your worktop.
Then fully tighten the screws (C) to secure the hob
into position.
(A) SEALING STRIP
(C) SCREW
(B) BRACKET