11
10
Moulded Trays - User Instructions
Moulded Trays are designed to provide a work or play surface together with support and
control in conjunction with any seating arrangement.
Using the tray
1. Ensure that the two vertical stems on the underside of the tray are securely
located in the wheelchair location points.
2. To fine tune the position of the tray in relation to the user, the locking knobs on the
underside of the tray must be loosened to allow the tray to be moved forwards or
backwards into the desired position. Re-tighten the locking knobs after adjustment.
Width adjustment
To change the width of the tray fittings to suit an alternative wheelchair;
1. Turn the tray over and loosen the four screws using a large flat bladed screw driver
(do not remove the screws completely).
2. Slide the adjustment tubes out/in to the desired width, ensuring that they remain parallel.
3. Re-tighten the screws.
Cleaning
A damp, soapy cloth can be used to clean the tray surface.
Warnings
• ON NO ACCOUNT SHOULD ANY HOLES BE DRILLED INTO THE TRAY TOP.
• ENSURE ALL LOCKING KNOBS ARE SECURE BEFORE USE.
• THE TRAY MUST BE REMOVED BEFORE TRANSPORTATION.
Moulded Sandals & Footstraps - User Instructions
Moulded Sandals and Footstraps are designed to provide support and control in
conjunction with any seating arrangement.
Do:
•
Ensure that straps are not twisted.
•
Ensure that buckles are adjusted so that when they
are fastened, there is no slack in the strap.
Care
Check that buckles and straps do not show signs of excessive wear or fraying - if you are
concerned about the condition of any item refer to your seating technician at the clinic or through
your supplier as soon as possible.
Cleaning
These items can be wiped clean using a damp, soapy
cloth. A soft brush can be used to remove heavier soiling.
Warning
THIS DEVICE IS NOT DESIGNED FOR USE AS PART
OF A SAFETY RESTRAINT SYSTEM FOR TRAVEL IN A
VEHICLE.
