Blastrac BS 180, Инструкция по эксплуатации

Страница: 20 / 60

Page 19
BS180 BLADES
• Because the cutting head swivels in the angle attachment, it is
recommended to remove the cutting head from the angle
attachment before changing the blades.
• Loosen hex head bolts with extended bolt wrench (See Figure
B). It is not necessary to remove bolts.
• Place blade into cutting head to the back of the bolts (See Figure
C).
• If the blade is wider than the cutting head, center blade to head.
• If blade is smaller than the cutting head, first pass blade should
be mounted in center of the cutting head.
• Use supplied extended wrench or a socket wrench with at least a
3" extension to keep a hand safely away from the sharp edge of
the blade.
• Securely block machine up (See Figure A).
Figure A
CAUTION: Never change cutting head or service blades
while machine is running
Figure B
Figure C
BLADE CHANGING
CAUTION: Blades are sharp.
• Sharp blades are imperative for good performance.
• Always wear gloves when changing blades.
• Tilt machine back.