Blastrac BS-110 II, Руководство по эксплуатации

Страница: 10 / 26

10
4 SETUP
4.1 Hydraulic fluid
Keep hydraulic fluid clean and on specified definite level. Only use a ISO32 compatible light fluid.
Non-compatible fluids could cause damage to unit or serious injury.
4.1.1 Hydraulic fluid level
See figure 4.1
– A
The machine has a fluid level sight window. The fluid should be
in the middle to the top of the window when the machine is sitting
in a normal operating position without a blade. If your machine
does not have a sight window, fluid should be ca. 2,5 cm (1")
from the top of the tank.
Check fluid level if there has been a leak, damaged or ruptured
hose or a loose fitting.
Change the complete fluid once a year
.
4.1.2 Adding or changing hydraulic fluid
To add fluid, unscrew the filler port cap from top of the machine.
See figure 4.1 - B
To change fluid, remove the filler port cap. Remove drain plug
from side of machine.
See figure 4.1 - B and 4.1. C
A container approximately ca. 9 litres (two gallons) in size will be
needed to drain fluid into.
Machine has a straining system, but add fluid through a filter or
funnel with a screen to keep fluid clean.
4.2 Speed control
Speed control knob can be adjusted while the machine
is running
Turning speed control knob counter clockwise
will make the machine run faster.
Turning speed control knob clockwise
will make the machine run slower.