Blastrac BMP-335, Руководство по эксплуатации

Страница: 4 / 30

4
www.blastrac.eu
1. Introduction
Before use, operators must be provided with information, instruction and training for the use of
the machine and the substances for which it is to be used, including the safe method of removal
and disposal of the material collected. All persons who are working with or maintaining this
machine must read the manual carefully and understand it fully. In case you sell the unit, hand it
on to the next owner.
Keep this manual always with the machine, to enable it to be referred to at any time.
Any other work not covered by this operating manual must not be carried out. Always use common sense
when working with machines.
This machine is designed for industrial use by professionals. Only authorized and trained personnel may
operate this machine. This machine is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge.
Blastrac BV offers a course on
the use of the machine in order to make the operating and maintenance personnel familiar with all elements of
the machine.
2. Machine description
The Blastrac scarifier BMP-335ELITE is supplied with a 400 Volt electric motor. The intended use of this
scarifier is to roughen up existing horizontal surfaces and removing coatings. It can be used on almost any
surface (concrete, asphalt, stone and steel). The machine may not be used for other purposes. The
manufacturer will not be liable for damage resulting from incorrect usage, in these cases the user assumes all
risks.
The drum of the scarifier revolves at +/- 1000 revolutions per minute. (RPM)
The depth of scarifying can be adjusted by the fine adjustment control at the front of the machine; by this
means it is possible to treat the surface with light or heavy cuts as is required.
The machine may not be used without an adequate dust extraction system. A specially designed Blastrac dust
collection system ensures dust-free operation of the machine and clean air at the workspace.
Application
The scarifier is a very versatile machine and with the appropriate cutters it may be used for the following
applications.

To roughen concrete

To clean most horizontal surfaces

To remove coatings

To corrugate concrete surfaces

To remove road markings

To make non-slip surfaces
The force of impact of a cutter is controlled by the depth adjustment. With the right depth adjustment, the
best performance is obtained to give a desired result.
With a suitable Blastrac dust collector work can be carried out without causing excessive dust in the work area,
this raises the life span of the machine and protects the health of the personnel.
The machine is sealed around which makes the use almost dust free when connected to an appropriate
Blastrac dust collector. Due to the fine adjustment and the possibility to lock the height adjustment, the depth
of cutting can be set very precisely, and the same working depth can be maintained.