Blastrac 1-9 DEZ, Руководство пользователя

Страница: 31 / 51

Operating Instructions 1-9DEZ
Edging Mode August 2005
6.1 Changing to the Edging Mode
This section (6.1) refers to Figure 6.1.1 on page 26.
The model 1-9DEZ is capable of cleaning surfaces within 1/2 inch of vertical
obstructions. (This is along the side of the machine. The 1-9DEZ can be
pushed as close as 1-1/2 inches from the front of the machine.) Performing the
following steps sets up the edging mode:
1. Put the 1-9DEZ in “Maintenance Mode” as described in Section 1.2.
2. Remove the two hex screws holding the retainer, seal and magnet on the side
of the machine where the edging is required. This requires a 3/16” hex key.
Be careful to keep abrasive from entering the holes in which the screws were
secured. You may want to cover these two holes with duct tape while in the
edging mode to protect the threads.
3. Move the machine to the area in which the edging will be done and see if the
machine can be moved freely. Adjust the height of the machine if necessary.
4. Begin cleaning in the normal fashion. Do not blast when the machine is away
from the vertical surface in the edging mode since the magnetic seal is no
longer present. Abrasive will disperse more readily from the side if the
magnet is not in place. Keep in mind that the machine will tend to lose more
abrasive while in the edging mode since the magnetic seal has been
removed.
WARNING: DO NOT USE THE MACHINE FOR NORMAL BLASTING WHEN IT HAS
BEEN PREPARED FOR EDGING. THE MAGNET, SEAL AND RETAINER MUST BE
REINSTALLED FIRST. CLOSE THE ABRASIVE VALVE BEFORE MOVING THE 1-
9DEZ AWAY FROM THE VERTICAL SURFACE. FAILURE TO DO SO MAY EXPOSE
NEARBY PERSONNEL TO HIGH VELOCITY ABRASIVE.
RIGHT SIDE EDGE MODE
25