Blastrac 1-8DEZMKII, Руководство по эксплуатации

Страница: 9 / 52

Operating Instructions 1-8DEZ
Safety Precautions
4
1.2 Cont’d
Most industrial and many commercial work sites will have already developed their own
Lock-Out/Tag-out procedures. The site safety personnel should be contacted to
establish the procedure to be used. If the site has no formal Lockout/Tag out procedure
the operator of this 1-8DEZ should be prepared to implement their own procedure
including training of all operating and maintenance personnel.
All drive guards must be kept in place and in good condition except during maintenance
or when repair work is being performed. Once maintenance or repair work is complete,
be sure all guards are securely remounted and operating.
Safety glasses with side shields should always be worn when working with or near the
1-8DEZ while in use.
Loose fitting clothing and gloves should not be worn when working with the 1-8DEZ.
Gloves can be worn for added protection.
The 1-8DEZ and all areas around the 1-8DEZ should be kept clean. Loose media in
particular can become hazardous for foot traffic. All abrasive leaks should be repaired
immediately to help keep the work area free of loose abrasive.
Any condition(s) that may result in damage to the 1-8DEZ or cause injury to the
operator and/or other personnel should be repaired immediately.
Do not attempt to make adjustments to the feed spout or any control cage components
while the 1-8DEZ is in motion or the blast wheel is operating. All adjustments must be
made after the 1-8DEZ as been put in Maintenance Mode.
Obey all safety and danger signs posted on the 1-8DEZ, read and understand the
Operating Instructions thoroughly, and follow all information posted where the 1-8DEZ
is being operated.
CAUTION: ALL SAFETY AND WARNING STICKERS MUST BE KEPT IN GOOD,
READABLE CONDITION. SEE DRAWING NUMBER 421-0013 FOR STICKER
DESCRIPTIONS AND LOCATIONS.
Do not operate the 1-8DEZ in the rain or when heavy moisture is present. Do not
expose the abrasive supply to any type of moisture. Sticky, tar related and rubber
surfaces should be avoided when using the Blastrac
®
1-8DEZ. Always drain unused
abrasive from the 1-8DEZ and empty the dust collector hopper before transporting the
1-8DEZ.