Blastrac 1-8DEZMKII, Руководство по эксплуатации

Страница: 29 / 52

Operating Instructions 1-8DEZ
Edging Mode
24
6.1 Changing The Edging Mode
Refer to Figure Number 5
The model 1-8DEZ is capable of cleaning surfaces within 1 / 2 inch of vertical
obstructions. (This is along the side of the machine. The 1-8DEZ can be
pushed as close as 1-1/2 inches from the front of the machine.) Performing the
following steps sets up the edging mode:
1. Remove the two hex screws holding the retainer, seal and magnet on the
side of the machine where
the edging is required. This requires a 3/16” hex
key. Be careful to keep abrasive from entering the holes in which the screws
were secured. You may want to cover these two holes with duct tape while in
the edging mode to protect the threads.
2. Move the machine to the area in which the edging will be done and see if the
machine can be moved freely. Adjust the height of the machine if necessary.
3. Begin cleaning in the normal fashion. Do not blast when the machine is away
from the vertical surface in the edging mode since the magnetic seal is no
longer present. Abrasive will disperse more readily from the side if the
magnet is not in place. Keep in mind that the machine will tend to lose more
abrasive while in the edging mode since the magnetic seal has been
removed.
WARNING: DO NOT USE THE MACHINE FOR NORMAL BLASTING WHEN IT HAS
BEEN PREPARED FOR EDGING. THE MAGNET, SEAL AND RETAINER MUST BE
REINSTALLED FIRST.
WARNING: CLOSE THE ABRASIVE VALVE BEFORE MOVING THE 1-8DEZ AWAY
FROM THE VERTICAL SURFACE. FAILURE TO DO SO MAY EXPOSE NEARBY
PERSONNEL TO HIGH VELOCITY ABRASIVE.