2
HCB x00
Part N
o
: 965x.01
Headend Controller
Headend control unit with 8A power supply
B
LINE
1. Safety and operating instructions
When assembling, starting-up and adjusting the modules, it is necessary to consider the system specific
references in the manual instruction!
The modules may only be installed and started up by authorized technical personnel!
When assembling the modules into the receiving points, the adherence of the EMC regulations is to be secured!
The assembly and wiring have to be done without voltage!
All active modules may only be operated with the Headend Controller HCB x00 or Bus Extender BEB x00!
The main voltage and the operating voltage of the modules working by DC have to be in complience to the operating
parameters described in the technical data.
With all work the defaults of the DIN EN 50083 have to be considered! Especially the safetyrelevant execution of the
DIN EN 60728-11 [1] is necessary!
2. Device variants
HCB 200
9652.01 Headend control unit with 8A power supply (100 ... 240 V~ input)
HCB 300
9653.01 Headend control unit with 8A power supply (48 V– input)
3. General
The Headend Controller HCB x00 is a module of the head end system B-LINE, which can also be used in the head end system
C-LINE/ C-LINE
+
.
The B-LINE system is conceived as a complete system for middle sized distribution networks, the C-LINE/ C-LINE
+
for smaller
distribution networks. All active modules are programmed via the central Headend Controller.
The individual modules will be addressed by the address switch at the Bus Extender (line) (BEB x00) and at the respective module
(position).
The status of the modules will be displayed by colored LEDs:
· Red - ERROR Control bus error
· Green - READY Operating status
· Yellow - DATA
Data traffic at the internal control bus
RJ 45 socket:
· Yellow - DATA
Data traffic (LAN/ WAN)
· Blue - LINK
Connection
