3
PALIOS-IPM2
Part N
o
: 5105.01
SBL
8 pole IP-/ ASI-TV Modulator
IP/ SFP/ ASI (MPEG2)
→
ATV (8x AM)
1. Safety and operating instructions
When assembling, starting-up and adjusting the modules, it is necessary to consider the system specific references in
the instruction manual.
The modules may only be installed and started up by authorized technical personnel. There are only permitted the
mounting styles indicated in the quick start guide, included with each module.
When assembling the modules into the receiving points, the adherence of the EMC regulations is to be ensured.
The assembly and wiring have to be done without voltage. For installation, only the supplied accessories (DIN rail clip
with screws and 19“ accessories) may only be used.
All active modules may only be powerd by the power supply HELIOS, HELIOS-P1 or QUASARIOS. Only connect the modu-
le with the accessory cables provided.
The mains voltage and the operating voltage of the modules working by DC have to be in compliance with the operating
parameters described in the technical data.
With all work the defaults of the DIN EN 50083 have to be considered. It is especially important to follow
DIN EN 60728-11[2].
The unit must only be mounted vertically. The ventilation slots as well as the circulation perforation of the modules is not be
obstructed in any way.
If installed in mounting cabinets a adequate heat circulation must be guaranteed. The mounting in closed cabinets without
air sufficient flow is
not allowed
.
For
DIN rail mounting
is important to note that between the heat sink and a neighboring module, a distance of 2 cm is
required. If the modules mounted on top of each, so they must be spaced 20 cm apart.
For
19“ mounting
all devices in the rack must be fitted with 19“ Edge Guide. Mounting the device using only the screw
holes at the front panel is insecure and discouraged. Furthermore, the operation of a fully occupied rack is only allowed
with an underlying 1-U fan box (at least 3 fans, 176 mm deep).
2. Device variants
PALIOS-IPM2
5105.01 IP/ SFP/ ASI (MPEG2)
→
ATV (8x AM)
3. General
The Smart Business Line (SBL) is a modern head end system, that is distinguished by its modular and compact design. A
userfriendly operating concept facilitates setup, configuration and maintenance of the system.
The PALIOS-IPM2 module selects 8 programs from up to 8 adjacent IP transport streams or from an ASI transport stream and
converts these into analoge TV signals to transmit it in cable networks. In this case, a maximum of 8 analog television channels
are generated from the available MPEG2 transport streams.
WEEE-Reg.-Nr. DE 50389067
