Blanco FE9085X, Инструкции по использованию, уходу и установке

Страница: 8 / 24

Instructions for Installation
DIMENSIONS AND INSTALLATION FEATURES
900
600
9
70 ÷ 980
150 min
600 min
TO FIT THE STABILISING CHAINS
In order to prevent tipping of the appliance it is equipped
with 2 chains for stabilising means and must be installed
and is required for safety reasons.
After the connection to gas and electrical supply is
completed and oven is located in its final position. The
following
MUST be done:
The 2 chains are fitted in the upper part of the rear right
and the rear left side. These two chains enable the cooker
to be fixed to the wall
1. The anchor used to attach the chains to the rear wall
must be of a type suitable for the purpose
2. If the appliance is installed between two cupboards, drill
a hole big enough on each side of the cupboards, to allow
the chains to pass through the holes and anchor the chains
within each cupboards
3. If the appliance is installed next to drawers, remove the
drawers, then carry out the procedure described in point 2.
Ensure the anchor does not interfere with the operation of the
drawers. If the cooker is to be installed next to an appliance,
such as a dishwasher, temporarily remove the appliance for
access to fit the stabilising chains.
4. Make sure the fixing to the wall is as close as possible to the
chain anchor point on the cooker and that the chains are
taught to effectively prevent the appliance from tilting.
Important: For a unique situation where the stabilising chains cannot be fitted, please contact
Blanco Technical Department for advice.
When the oven is moved for servicing – THE CHAINS MUST BE RE-ATTACHED by the Technician.
THE MANUFACTURER DECLINES ANY AND ALL RESPONSIBILITIES FOR DAMAGES TO
PROPERTY OR INJURIES TO PERSONS OR ANIMALS DERIVING FROM INCORRECT
INSTALLATION OR USE OF THE EQUIPMENT SET OUT IN THE MANUAL.
Nominal volume of the oven
101 lt
8