Blanco BSID4610X, Инструкция по эксплуатации

Страница: 18 / 40

17
If it is necessary to open dishwasher door during the washing cycle,
there will be a 1-minute delay before the program can be resumed.
After correctly closing the door, press the START/PAUSE button (4)
again. This operation may negatively affective the progress of the
washing cycle.
END PROGRAM
The end of the program is indicated by a short signal acoustic and from
the “End” visual notification on 3-FIGURE DISPLAY (12) (Section 3.1).
By pressing the PROGRAM SELECTION button (2) the “End” visual
signal will vanish from the display and the dishwasher is ready to
continue a new cycle
•
Always try to run the dishwasher fully loaded.
•
Do not wash the dishes in running water.
•
Use the washing program that is most appropriate for each type of
load.
•
Do not carry out any preliminary rinsing.
•
If available, connect the dishwasher to a hot water supply up to 60°C.
The phosphates contained in dishwasher detergents are harmful to the
environment. To avoid using excessive amounts of detergent and to save
on electricity, observe the following:
•
separate the more delicate items from dishes that are more resistant
to aggressive detergents and high temperatures;
•
do not pour the detergent directly on the dishes.
ENERGY MANAGEMENT
After 5 minutes of waiting (washing cycle completed, stopped or set but
not started) the dishwasher switches to a standby state to reduce
energy consumption.
In this state, the dishwasher indicator panel (lights or display depending
on model) functions more slowly (switch-on once every 5 seconds).
REMOVING THE DISHES
At the end of the washing program, wait at least 20 minutes before
removing the dishes, to allow them to cool down. To prevent any water
droplets on the upper basket from falling on the dishes in the lower
basket, it is advisable to unload the lower basket first, and then the
upper basket.