7
Installation
Water Supply and Drain
Cold water connection
Connect the cold water supply hose to a threaded 3/4
inch connector and make sure that it is fastened tightly
in place.
If the water pipes are new or have not been used for
an extended period of time, let the water run to make
sure that the water is clear. This precaution is needed
to avoid the risk of the water inlet to be blocked and
damage the appliance.
About the safety supply hose
The safety supply hose consists of the double walls. The hose's system guarantees its intervention
by blocking the flow of water in case of the supply hose breaking and when the air space between
the supply hose itself and the outer corrugated hose is full of water.
WARNING
A hose that attaches to a sink spray can burst if it is installed on the same water line as the
dishwasher.
If your sink has one, it is recommended that the hose be disconnected and the hole plugged.
How to connect the safety supply hose
1. Pull the safety supply hoses completely out from storage compartment located at rear of
dishwasher.
2. Tighten the screws of the safety supply hose to the faucet with thread 3/4 inch.
3. Turn water fully on before starting the dishwasher.
How to disconnect the safety supply hose
1. Turn off the water.
2. Unscrew the safety supply hose from the faucet.