Blanco BFD9156WX, Инструкция по эксплуатации

Страница: 27 / 36

27
461308374 12-2014
INSTRUCTIONS FOR THE INSTALLER
G
AS CONVERSIONS
REPLACING THE INJECTORS
Our burners can be adapted to different
types of gas by simply installing the injectors
suitable for the gas you want to use. To help
the installer, the table
(see TECHNICAL
FEATURES
paragraph
)
gives the burner
nominal heat input, injector diameter and
operating pressure of the different gas types.
Comply with the following instructions:
Injector replacement - Cooktop burners.
To change the injectors on the cooktop,
remove the burner cup and head and with
a 7 mm Ø socket spanner replace them (fig.
20).
After having replaced the injectors, it will
be necessary to proceed with burner
adjustment as explained in the previous
paragraphs.
20
21
REPLACING THE ELECTRICAL
COMPONENT
• The rear protection will have to be removed
in order to change the electrical heating
elements, spit motor, terminal board and
power cable.
•
If you have to change the power
cable (see TECHNICAL FEATURES
paragraph
), always keep the earth
wire longer than the phase wires
and, in addition, follow all the
instructions given in the “ELECTRICAL
CONNECTION” paragraph.
• To change the oven lamp see the
instructions
REPLACING THE OVEN
LAMP
paragraph
.
•
To change lamp holder (P) (fig. 21)
, use
a screwdriver to push the clamp tips (M)
and pull the lamp holder out towards the
inside of the oven.
• To change the lamp holder, the spark
generator and the spark electrodes, the
work top has to be removed as indicated
in the paragraph «
REPLACING THE
TAPS»
.
• To change the programming accessory,
the thermostat, the commutator and the
warning lights, remove the front panel by
unscrewing the three fixing screws which
lock it to the front frame.