Blanco BFD9156WX, Инструкция по эксплуатации

Страница: 15 / 36

15
9
461308374 12-2014
INSTRUCTIONS FOR THE USER
CLEANING AND MAINTENANCE
COOKTOP
The burner caps and burner heads need to be
cleaned after each time they are used with warm
soapy water, rinsed and then dried well to keep
them in good condition.
WARNINGS:
• After cleaning, check that the heads burners
and the relative burner caps, are correctly
positioned in their housings (fig. 9).
• Take care not to disturb the ignition spark plugs
or flame failure devices.
• If you find a tap is difficult to open or close do
not force it but call for technical assistance
urgently.
• The appliance is not intended to be operated by
means of an external timer or separate remote-
control system.
STRUCTURE
All the cooker parts (in enamelled or painted metal,
steel, or glass) should be cleaned frequently with
warm soapy water and then rinsed and dried with
a soft cloth.
DO NOT use harsh abrasive cleaners or sharp
metal scrapers to clean the oven glass door since
they can scratch the surface, which may result
in shattering of the glass. NEVER use sponges
or abrasive products, and aromatic or aliphatic
solvents to remove stains or adhesives on the
painted or stainless steel surfaces.
DO NOT leave vinegar, coffee, milk, salty water or
the juice of lemon or tomato on the surface for any
length of time.
OVEN CAVITY
Do not spray or wash the thermostat bulb with
acid based products (check the product label
before use).
The manufacturer cannot be held liable for any
damage caused by incorrect cleaning
.
The oven cavity should be cleaned after each use
to remove cooking residuals and or grease or sugar
which, if burnt on when the oven is used again, will
form deposits or unremovable stains as well as
unpleasant smells.
To maintain the shine of the enamelled parts, clean
them with warm soapy water, rinse and dry them
thoroughly. ALWAYS wash the accessories used.
OVEN SIDEWALL GRIDS (fig. 10)
To allow for a better cleaning of the side grids, you
can extract them this way:
1. Push with a finger on the last of the slots to
release the grid from its hold.
2. Lift it towards the top and extract the grid.
To put them back into place, reverse the order of
this operation.
10