Blanco BFD9054WX, Инструкция по эксплуатации

Страница: 23 / 36

23
TECHNICAL INFORMATION
• The installations, conversions and
maintenance operations listed in this part
must only be carried out by authorised
personnel. The manufacturer cannot
be held responsible for any damage to
persons or property resulting from an
incorrect installation of the appliance.
• If the appliances is installed on a base ,
measures must be taken to prevent the
appliance from slipping from the base
• The appliance is not intended to be
operated by means of an external timer or
separate remote-control system.
• The safety and automatic adjustment devices
of the appliances may, during its life, only
be modified by the manufacturer or duly
authorised supplier.
• This appliance shall be installed only by
authorised personnel and in accordance with
the manufacturer’s installation instructions,
local gas fitting regulations, municipal building
codes, electrical wiring regulations, AS 5601
- Gas Installations and any other statutory
regulations.
• Failure to install the appliance correctly could
invalidate any manufactures warranty and
lead to prosecution under the above quoted
regulation.
• Before installation, make sure that local
distribution conditions (gas and electrical) are
compatible with the appliance’s adjustment.
Refer to data label for gas type.
• As it is not connected to a device for the
evacuation of the products of combustion, it
must be installed in accordance with current
regulations and used in a well ventilated
location. Particular attention must be paid to
the regulations on ventilation.
VENTILATION
All rooms require an openable window or
equivalent, while some rooms require a permanent
vent in addition to the openable window.
Ventilation must be in accordance with AS5601
- Gas Installations. In general, the appliance
should have adequate ventilation for complete
combustion of gas, proper flueing and to maintain
temperature of immediate surroundings within
safe limits.
The use of a gas appliance results in production
of heat and moisture in the room in which it is
installed. Ensure that the kitchen is well ventilated;
keep natural ventilation holes open or install
a mechanical ventilation device (mechanical
extraction hood).
Prolonged intensive use of the appliance may call
for additional ventilation, for example increasing
the level of mechanical ventilation where present.
UNPACKING YOUR COOKER
• Once the packaging has been removed,
thoroughly check that the appliance is in perfect
condition. If you have any doubts do not use the
appliance and call our Service Centre.
• Do not move the appliance by the handles.
• Some parts mounted on the appliance are
protected by a plastic film. This protection must
be removed before using the appliance. We
recommend slitting the plastic film along the
edges with a sharp knife or pin.
The packaging materials used (cardboard,plastic
bags, polystyrene foam, nails etc.) must not be left
anywhere within easy reach of children as they are
a potential hazard source.
Some problems can be caused either as the results of simple maintenance operations or by incorrect selection
of settings. Prior to contacting a Service Centre please check the following chart.
PROBLEM REMEDY
The appliance is not working • Make sure the gas cock is open
• Check the plug is in
• Check that the knobs are set correctly for cooking and then
repeat the operations given in the handbook
• Check the electrical system safety switches (rCD). If there is
failure in the system call an electrician in.
The thermostat is not working • Contact Service Centre.
The oven light does not switch
on
• Make sure the lamp is firmly screwed in place
• Buy a lamp for high temperatures at one of our Service
Centre and fit it following the instructions given the
<REPLACING THE OVEN LAMP> paragraph.
Warning: Servicing should be carried out only by authorised personnel.
TROUBLESHOOTING
INSTRUCTIONS FOR THE INSTALLER