6
T E C H N I C A L
I N F O R M AT I O N F O R
THE INSTALLER
This appliance shall be installed only by
authorised personnel and in accordance with
the manufacturer’s installation instructions,
local gas fitting regulations, municipal codes,
e l e c t r i c a l w i r i n g r e g u l a t i o n s ,
AS 5601/AG 601- Gas Installation and any
other statutory regulations. Ventilation must
be in accordance with AS 5601/AG 601- Gas
Installation. In general, the appliance should
h a v e a d e q u a t e v e n t i l a t i o n f o r c o m p l e t e
combustion of gas, proper flueing and to
m a i n t a i n t e m p e r a t u r e o f i m m e d i a t e
s u r r o u n d i n g s w i t h i n s a f e l i m i t s .
The wall and bench surfaces must be capable
of sustaining temperatures of 75° C.
All laminates, fixing adhesive and surfacing
materials should be certified suitable for this
temperature.
3) INSTALLING THE COOKTOP
Check that the appliance is in a good condition after
having removed the outer packaging and internal
wrappings from around the various loose parts. In
case of doubt, do not use the appliance and contact
qualified personnel.
Never leave the packacing materials (cardboard, bags,
polystyrene foam, nails, etc.) within children’s reach
since they could become potential sources of danger.
The measurements of the opening made in the top of the
modular cabinet and into which the hot plate will be
installed are indicated in either fig. 7.
Always comply with the measurements given for the hole
into wich the appliance will be recessed (see fig. 7).
Any adjoining wall surface situated within 200 mm from the
edge of any hob burner must be a suitable non-combustible
material for a height of 150 mm for the entire length of the hob.
Any combustible construction above the hotplate must be at
least 600 mm above the construction above the top of the
burner and no construction shall be within 450 mm above the
top of the burner. A minimum depth of 60 mm from the top of
the work surface must be provided for this appliance.
4) FIXING THE HOT PLATE - STANDARD
FLUSHLINE
The hot plate has a special seal which prevents liquid
from infiltrating into the cabinet. Strictly comply with
the following instructions in order to correctly apply
this seal:
- Detach the seals from their backing, perfectly that
the transparent protection still adheres to the seal
itself.
- Overturn the hot plate and correctly position seal
“E” (fig. 8) under the edge of the hot plate itself, so
that the outer side of the seal perfectly matches the
outer perimetral edge of the hot plate. The ends of
the the strips must fit together without overlapping.
- Evenly and securely fix the seal to the hot plate,
pressing it in place with the fingers and remove the
strip of protective paper from the seal and set the
plate into the hole made in the cabinet.
- The prospective walls (left or right) that exceed the
working table in height must be at a minimum
distance from the cutting as mentioned in the
columns and the scheme.
INSTALLATION
FIG. 8
FIG. 9
A
B
Standard flushline installation
650
492
COMPLY WITH THE DIMENSIONS
Installation into granite
650 492
FIG. 7
Содержание BCGF75
Страница 1: ......
