Instruction Manual TRI-BEAM48
27380
–
48 Element High Gain Tri-Beam Aerial
Kit Contents:
•
Aerial
•
Screws
•
F Connector
•
Weather Boot
You will need:
•
Flat Head Screw Driver
•
Suitable Spanner
Features:
•
High performance compact Tri Beam aerial.
•
Shorter aerial than similar aerials for lofts or areas
with limited space.
•
Optimised design for LTE rejection.
•
Partially pre-assembled for ease of installation.
•
Male F connection with weather boot and F female connector.
•
Very flat frequency response over all operating bandwidths.
•
Supplied with weather resistant clamp, suitable for horizontal or vertical polarization.
1.
Assemble the aerial
a.
Expand the 3 aerial booms.
b.
Remove the screw on the back of the aerial (where the 3 booms are secured) and push the plastic spacers together
so the holes match up. Insert the screw through the hole on the plastic spacer and screw in using a flat head screw
driver. This will hold the plastic spacers in place.
c.
Repeat step
b.
with the plastic spacer joining the booms together in the middle of the booms.
d.
Assemble the dipole on the single boom at the rear end of the aerial. Remove the bolt and position the dipole into
place. Then, replace bolt and tighten.
e.
Push the reflector sections into the rear triangular plastic housing at the back of the aerial ensuring both spring
buttons are located back through the hole.
a.
b.
c.
d.
e.
