Page 7
Installing the Handle Bar
Before using your XTR-COMP II, loosen the
4 bolts from the Billet Aluminum Stem with
the Allen Wrench provided, and then remove
the stem cap as shown in Fig 1.
Place handle bar onto the Billet stem with the
hole facing down towards the threaded bolt
as shown with arrow in Fig 2.
Place the Billet Stem cap on top of the handle
bar and tighten the bolts to secure the handle
bar onto the stem as shown in Fig 3.
Quick Release Deck
The XTR-COMP II has a quick release
deck which makes it easier to gain access
to the batteries and the pc board. To
open simply lift up from the rear of the
deck and it will open up towards the
handle bar. (Fig. 4)
Intergraded Seat Base
The XTR-COMP II comes with a seat base
built in to the scooter. Having this base built in
to the Scooter will make it easy to install and
remove your seat. To install the seat, remove
the pin from the side of the scooter. (Fig. 5)
Then place the seat post into the base on the
deck (Fig.6) and replace the pin in the side of
the scooter to secure the post. Place the seat
2
Fig. 3
