Blade GB200, Руководство пользователя

Страница: 8 / 16

8
EN
Changing the Camera Mount
GoPro ® users
The GB200 comes with the CGO1 camera mount
pre-installed. If you are using a GoPro
®
3/3+ camera
with your gimbal, it is necessary to change the
camera mount.
1. Turn the camera mount on the gimbal until the set
screw faces the notch in the gimbal arm.
2. Loosen the set screw using the small hex wrench
included, as shown.
3. Slide the camera mount away from the gimbal
motor while carefully sliding the gyro plate from
the camera mount.
4. Carefully remove the gyro board from the gyro
plate. Double-stick tape fi rmly holds the board on
the mount.
5. Install the gyro board in the alternate
camera mount gyro plate. The plates are not
interchangeable.
6. Wrap the gyro board wire harness loosely
clockwise one whole turn around the end of the
camera mount toward the gimbal motor.
7. Slide the gyro plate onto the camera mount.
8. Slide the camera mount onto the motor shaft,
taking care to align the fl at on the motor shaft with
the set screw on the mounting plate.
9. Insert and tighten the set screw.
2
3
3
5
7
8
9
6
CGO1 mount
GoPro ® 3 mount