7
EN
Installing the Mounting Plate
Installing the Gimbal
The CGO2+ camera gimbal is compatible with
350 QX3 and Chroma
™
quadcopters. Install the
appropriate mounting plate using the 3 included
M2.5 x 10 screws.
Do not overtighten.
IMPORTANT:
If you are mounting the CGO2+ to the
350 QX3, you must fi rst install the 350 QX3 tall
landing gear (BLH8105).
Install the gimbal by lining up the mounting rails of the
gimbal and the mounting plate and pushing towards
the rear of the plate as shown at left until it locks into
place.
To remove the gimbal, push in the retaining clip at
the front of the mounting plate and pull the gimbal
forward.
Connect the harness from the gimbal to either
the exposed wire harness from the 350 QX3 or
to the recessed plug in the bottom of the Chroma
quadcopter.
