Blackstar ID:CORE STEREO 100, Руководство пользователя

Страница: 17 / 60

17
FS-12 5-way programmable footcontroller (not supplied)
Connect this footcontroller to the Footswitch socket on the rear of your amplifier
using any standard mono guitar cable or speaker cable.
Switches ‘A’-‘C’ correspond to the ‘CH 1’ – ‘CH 3’ switches on the front panel
of your amplifier. Pressing any of the ‘A’-‘C’ footcontroller switches will recall the
corresponding patch within the current Bank. Banks can be navigated by a single
press of both switches ‘A’ and ‘B’ simultaneously (Bank down) or a single press
of both switches ‘B’ and ‘C’ simultaneously (Bank up). All 36 amplifier patches (12
banks of 3) can be accessed using the FS-12 footcontroller.
Switches ‘D’ and ‘E’ on the FS-12 footcontroller are programmable and can be
configured to a number of different functions to suit your preference. By default,
Switches ‘D’ and ‘E’ will control the Looper feature of the amplifier, and will behave
as described in the following table.
To change this default setting, connect the amplifier
to your computer via USB and use the free Blackstar
INSIDER software to make your personal selection from
various options such as Modulation/Delay/Reverb On/Off,
Modulation/Delay Tap Tempo, Super Wide Stereo On/
Off, amongst others. Please see the Footcontroller section
of the INSIDER software for detail of the programmable
functions.
Holding down the ‘D’ and ‘E’ switches will activate Tuner Mode of your amplifier.
With the multifunctional FS-12 footcontroller you gain access to a fully chromatic
tuner with note and cents display information appearing on the footcontroller display
and LEDs. Press any switch to exit Tuner Mode.
FS-12 + FS-13 7-way switching
Connect the FS-12 5-way footcontroller to your amplifier as detailed above, then
connect your supplied FS-13 2-way footcontroller to the ‘EXT.’ socket of your FS-12
footcontroller, using any standard mono guitar cable or speaker cable.
In this configuration you can add two extra, programmable switches which are
configurable via the Blackstar INSIDER software. Please see the Footcontroller
section of the INSIDER software for detail of the programmable functions.
By default, switch ‘A’ on your FS-13 will toggle the current Modulation effect, and
switch ‘B’ will toggle the current Delay effect. When using this 7-way switching
configuration the two markers at right side of the display of the FS-12 will show the
on/off state of the effect for each switch, as shown below.
English
A B C D E
AMP EXT.
A B C D E
AMP
EXT.
FS-12 FS-13 (supplied)
A
FS-13 Effect switch
toggle states
B
ON
ON
LOOPER MODE
Action
D (press)
Play/Record/Start and
Stop overdub
E (press) Stop playback/Cancel
E (hold) Erase loop memory
D + E (press) Undo last overdub