Installation
7
This step can be skipped unless your card has integrated I/O connectors.
Secure any protruding BNC connectors, to the Blackmagic rear module,
by screwing the supplied nuts clockwise on the screw thread of each BNC
connector. Each screw should only be finger-tight as over-tightening may
damage the rear module. Securing the BNC connectors should prevent
damage to the card if one of the I/O connectors is accidentally tugged by an
attached cable.
If you have just installed a Blackmagic OpenGear Optical Fiber, replace the SFP module and push the wire
tab back to its original position.
If you are not ready to connect fiber optic cables to the LC connector port, replace the protective cap
At the front of the frame, raise the door until the frame extender arms are
horizontal and then push the door in to the frame until the door catches click
in to place. The frame door should now be secured.
You can now connect cables to your Blackmagic OpenGear Converter.