Installation
6
When the door has been withdrawn to its maximum extent, gently lower
the door on its frame extender arms, so it no longer obscures access to the
inside of the frame.
With the frame door open, insert the Blackmagic OpenGear Converter card
into the card guides which correspond with the Blackmagic rear module. The
card should be inserted so that the white lever faces the front of the frame
and rests on the inside base of the frame. The white lever serves no purpose
during installation and is only used when removing a card.
Gently slide the card along the card guides until you feel the card press in to
a slot at the rear of the frame. Any integrated I/O connectors, such as HDMI
and optical fiber connectors, should protrude through the corresponding
holes of the Blackmagic rear module.
NOTE: Before installing a Blackmagic OpenGear Optical Fiber
If you are installing a Blackmagic OpenGear Optical Fiber card, remove the protective cap from the LC
connector port of the fiber optic module. Save the protective cap as it will be needed to prevent dust if the
LC connector port is exposed when no fiber optic cables are connected.
Pull the wire tab outward to an angle of 90° to release the SFP module latch.
Grip the main portion of the SFP module, between your thumb and forefinger, and pull it from the SFP
module port. Do not pull the wire tab as it might break and prevent the SFP module from being removed.